Skip to main content

Posts

Showing posts from May, 2015

Radio Level Load Balancing in Ruckus

If Client Load balancing is not working as expected in AP Level , Band Level, SSID Level Load Balancing, you still can configure Radio Level Load Balancing in you Ruckus Zone Director Controller for your APs. It is simple to do this. Login to the ZoneDirector with Command Line and go to Global Configuration Mode. Enter to Load-Balancing Mode and enable the Radio Level Load-Balancing. It is disable by default. Use wifi 0 for 2.4GHz and wifi 1 for 5GHz. You may adjust threshold level if you wish to. Check the below picture for your reference. Here I show with Ruckus Zone Director 1106 and AP R710. Zone Director Firmware is 9.8.2.0 build 27. Have a good time. (Be knowledgeable, pass it on then)